Toyota Land Cruiser 70 from 1991 PU eccentric bushing set for 50mm lift

• Toyota

• Land Cruiser 70

Get your Land Cruiser's suspension perfectly aligned again after a lift! With the ultimate complete kit including eccentric bushes (Caster-Kits) made of polyurethane (PU), you'll give your Toyota Land Cruiser 70- or 73-series a full suspension overhaul.

This kit was specially developed for modified vehicles with a 50 mm (2-inch) suspension lift. Lifting the vehicle changes the geometry of the front axle – the eccentric bushes for the front trailing arms precisely correct this altered caster angle. Our orange comfort version (75 ShA) permanently restores the exact axle geometry, brings back stable straight-line driving and eliminates vague handling and steering shimmy, while maintaining the necessary driving comfort for long expeditions.

Why this complete kit with caster correction for 50mm lifts (75 ShA)?

The hardness of 75 ShA is the perfect choice for all-round and touring vehicles: it offers noticeably more solid guidance for the trailing arms and Panhard rods than standard rubber, but is flexible enough to absorb hard impacts in a material-friendly way and protect the suspension points on the frame.

• Perfectly matched to 50 mm lift: Essential for suspension lifts of 50 mm (2 inches) or more, to bring the front axle's caster angle back into the optimal range and keep the steering precise.

• Precise axle guidance: Prevents uncontrolled wandering of the solid axles and ensures maximum directional stability on the road and off-road.

• Full articulation: The bushings are designed to optimally support the extreme movement of the suspension off-road.

• Weather and chemical resistant: Absolutely insensitive to mud, water, oil, grease and extreme temperature fluctuations.

• High durability: Unlike rubber, PU does not become porous, does not age, and does not wear out even under high continuous loads.

⚠️ IMPORTANT NOTE: Measure trailing arm width at the frame!

Different trailing arms were installed ex-factory on Land Cruiser models. Please be sure to measure the width of your front and rear trailing arms at the point where they are attached to the frame before purchasing, so we can send you the correct bushings!

There are two different widths for the frame connection:

• Width (front/rear at frame): optionally 35 mm or 40 mm

Scope of delivery (suspension bushing kit with caster correction)

The set contains all bushings for the front and rear axles, including the necessary metal sleeves:

1. Front trailing arms (axle connection): 4x PU eccentric bushings + 4x metal sleeves (for caster correction with 50 mm lift)

2. Front trailing arms (frame connection): 2x PU bushings + 2x metal sleeves (width as selected: 35mm or 40mm)

3. Rear trailing arms (axle connection): 4x PU bushings + 4x metal sleeves

4. Rear trailing arms (frame connection): 2x PU bushings + 2x metal sleeves (width as selected: 35mm or 40mm)

5. Front Panhard rod: 2x PU bushings + 2x metal sleeves

6. Rear Panhard rod: 2x PU bushings + 2x metal sleeves

Suitable vehicle models

• Toyota Land Cruiser 70-series (LJ70, RJ70, HZJ70 etc.): Model years 1988 – 1995 (suitable for versions with 35mm or 40mm wide trailing arm eyes)

• Toyota Land Cruiser 73-series (LJ73, HZJ73 etc.): Model years 1990 – 2002 (suitable for versions with 35mm or 40mm wide trailing arm eyes)